2014 - 2026 Indian Chief Classic, Chieftain, Springfield & Roadmaster 2014 - 2025 Indian Chief Vintage
* Click or Tap to Activate Item *
Dual Tour Max provides the largest seating positions available for your Roadmaster or Chieftain (with Indian trunk added). Passenger seating area is increased over five inches in width compared to our Sport Dual Tour model.
Corbin maximized the seating area and positioned the rider bucket in the sweet spot to offer the best possible ergonomics and long range comfort. Sculpted seating platforms conform to the shape of your body to give more square inches of even support and eliminate hot spots and pressure on your tailbone.
Neutralized seating platforms help to hold your body in place and curbs sliding in the saddle. This also helps to relieve rider fatigue by taking pressure off your wrists and knees. Our exclusive Comfort Cell foam material on the inside provides a firm, resilient ride that supports your body indefinitely. Over time, Comfort Cell will break in and adapt to provide a personalized fit to your body.
Bucket shaping of the front seating area gives an unprecedented amount of body support. Notice how it curves up at the back to provide five inches of support to your lower back. Towards the front of the bucket we design the saddle narrower to allow for ground reach. Smaller riders may prefer to slide forward and out of the bucket at stop signs for best ground reach.
Dual Tour Max accepts an adjustable backrest in the rider's seating area. Backrest installs and removes easily with a single bolt and adjusts to provide a tailored fit to rider posture. We've built in special hardare that also allows the backrest to be adjusted fore and aft and also folds down when mounting the bike.
Backrests are available in several styles to suit your taste. We've found the #BR Ovalbac (shown) to provide the right blend of clean visuals and rider support. Gives you an additional ten inches of vertical support! Covered with genuine leather to match your saddle and built up with Comfort Cell foam for long lasting comfort. At the rear we offer a variety of finishing plate options. Our standard plate is a black leather look, but we also offer a smooth paintable model, wood grain or can supply one prepainted gloss black.
Corbin's Dual Tour Max has the option of electric seat heaters for a bit of luxury on those chilly rides. Heated saddle has rider and passenger areas that are controlled independently via conveniently located switches in the left side panels. Our seats plug directly into wiring that exists on the motorcycle for simple integration.
Our Fibertech base material and patented manufacturing process allows a perfect fit to the lines of the fender and tank. This rigid baseplate provides the saddle with a firm foundation to support the carefully designed ergonomics of the foam. The entire seat rides on rubber bumpers to protect your paint job and mounts to your bike with a tongue in the front and single screw into your fender at the rear.
On the outside we use the highest quality materials available for a luxurious ride that breathes with your body. We've designed a cover pattern that blends with the visuals and allows a variety of customization options. In keeping with the design of the OEM components, we've incorporated a diamond stitching so you keep consistent look across all components and that vintage appeal.
Shown here we used: Gray Alcantara seating, Matte Black sides and stud band, Brushed Aluminum welts, White Heavy stitching, and Light Silver Corbin logo.
For your Indian Roadmaster we also offer an improved passenger trunk armrest. Just like the Corbin saddle, our trunkrest maximizes body contact to disperse weight over a greater area and reduce hot spots. Sculpted to fit your passengers back and fit perfectly to the Indian trunk. Comes fully coordinated to your Corbin saddle. Corbin trunk armrest includes BOTH the upper trunkrest and the small lower pad near the seat.
Regarding Indian Concert Saddlebag Audio Kit: We have provided room under the basepan for the amplifier used in this kit, but the Corbin amplifier relocation bracket MUST be used. Our bracket lowers the mounting point of the unit to allow for the improved seating position and ergonomics of the Corbin saddle. We provide this bracket at no charge if you own or are purchasing the Corbin saddle.
This version of Corbin's Dual Touring Saddle is specially designed to work with the Indian Roadmaster trunk. For our standard model that works with two backrests, please see THIS page.
UNIQUE TECHNOLOGY:
The design and manufacture of Corbin products is so unique that
Mike Corbin himself holds more than 60 United States Patents!
From the process itself to new innovations like the Corbin
Glovebox, you can count on highly functional and unique products
that work. Corbin products are manufactured under one or more of
the following US Patents: 6,848,156 B2; 6,729,516 B2;
D 489,540S; 6,655,740 B1; 6,422,648 B1; 5,544,937;
5,608,957; 4,953,911; D545,073S & 6,971,714 B1.
FIBERTECH™ BASEPAN:
A purpose-built hybrid material that provides a firm foundation
to support the carefully designed ergonomics of the Corbin
saddle. It provides a precision fit to every arc and contour of
the machine and rides on rubber bumpers to protect your paint.
We always design our basepans as flat as possible so bumps or
odd shapes don't telegraph through the foam to your body.
Click the button at left to learn
more...
COMFORT CELL® FOAM:
The heart of the Corbin saddle! Our exclusive, purpose-built
foam material, called Comfort Cell, was created to
provide a firm, resilient ride that doesn't break down. This
means it will support you for long days on the road. Over time,
Comfort Cell will break in to provide a personalized fit to your
posture and even greater comfort!
For the complete story, just click the
button.
ERGONOMIC SHAPING:
A major part of the design criteria of the Corbin saddle is its
ergonomic shape. This means the saddle's foam shape is designed
to emulate the curves of the human body. This provides more
square inches of body contact and helps eliminate hot spots.
This shaping also neutralizes the seating platform to help curb
sliding in the saddle, which reduces fatigue. In a nutshell:
more comfort for a longer ride!
Click the button at left for an animation that shows
how it works.
PATENTED MANUFACTURING TECHNOLOGY:
Always an innovator, Mike Corbin invented Integrated Molding
technology, which is now the process by which all Corbin
saddles are made. This process allows extremely tight
tolerances and creates a chemical bond between the foam and
base material.
To see what this is all about, click the button for
more information.
GENUINE LEATHER:
We use leather in all panels of the seat that contact your body.
This provides a luxurious ride that breathes with your body.
Leather will also break in along with the foam shape to support
a personalized fit. Available in a wide range of textures and
styles to suit your taste.
For more information about leather seating,
click away.
CORBIN BACKREST SYSTEM:
The first and most versatile removable backrest system available
for motorcycles! Corbin's backrests provide added vertical back
support and long-range comfort. Supported by internal hardware
for a very clean look, the backrests adjust to the rider's profile
for a tailored fit and install or remove easily as desired.
A very popular option! Click the button for
additional information...
ELECTRIC HEAT:
As an option, we can include electric heat in this saddle!
This option provides a true bit of luxury for when the
temperature starts to drop. Installation is simple, with the
major components pre-built into the saddle. Just wire in the
included pigtail and you're ready to roll.
Click the button at left for
complete information...
Warning!
Heater elements should never be installed in motorcycle seats
used by riders who cannot sense heat.
VISUAL 3D CONFIGURATOR
Interactive Design Tool
#I-RM-DT
Dual Tour MAX, no heat, 2014-2026 Indian Touring Motorcycles
Explore colors, materials and design options in our interactive
visual design tool. Experiment, share your creation or add the
finished design to your shopping cart.
Concerned about how a material will look? We will gladly send
samples at no charge. Visit our
materials page
and use the chatbot to place your request. Limitations apply.
Saddle Cream
Take good care of your new seat and it will take care of you!
Perfect for all your leather goods.
$25
Thumbscrews
Makes seat installation and removal a tool-free snap!
Machined from one piece of stainless steel for a very clean look.
Available in many popular sizes.
*Shop*
Standard Ovalbac
Our most popular backrest is the perfect blend of form and function.
Nine inches of support.
$383.
*Learn More*
Standard Backrest
Similar to the Standard Ovalbac, but without the hole.
Available with chrome studs too.
$383.
*Learn More*
Ovalbac Edge
Edge Ovalbac designed to complement bikes with more angular lines.
Eight inches of support.
$383.
*Learn More*
Ovalbac Large
Like the Standard Ovalbac, but with more support.
10" H x 12.5" W contact area.
$383.
*Learn More*
Ovalbac Tee
Extra-large support cut away to provide clearance for the
passenger's legs. Thirteen inches tall.
$383.
*Learn More*
Ovalbac Gunfighter
The functionality of a backrest with the smallest appearance
possible. Provides eight inches of support.
$383.
*Learn More*
Gunfighter
Often used as a rider's backrest in Gunfighter seat models.
Provides eight inches of vertical back support.
$383.
*Learn More*
Corbin Glovebox
Glovebox bolts to your Standard model backrest
(#297-SB & #02-SB) to provide four liters of locking storage.
$518.
*Learn More*
Measurements:
Rider seating: 16" wide x 18" long x 5" deep Rear area: 16.5" wide x 13.5" long Trunkrest: 16" wide x 12" tall Trunkrest Opening: 18" wide
Corbin's Heated saddle will plug directly into wiring that is already on the Indian.
Fits Indian Roadmaster or any of these models with the addition of the Roadmaster style trunk:
Chief Vintage (except 2026)
Chief Classic
Springfield
Chieftain
AUDIO KIT NOTE: Corbin amplifier bracket (#I-AMP-BK) is required for the Corbin Dual Tour saddle to function with the Indian Concert Saddle Bag Audio Kit. This bracket lowers the unit so we can keep the improved ergonomics and rider positioning of the Corbin designed saddle. Bracket will be provided free of charge to owners of the Corbin Indian saddle.
NOTE: This saddle does not fit the 2026 Indian Chief Vintage. Please refer to THIS MENU for available saddles.
Corbin saddles (with very few exceptions) include
Genuine Leather Seating
to provide a luxurious look and feel... don’t let anybody tell you
that vinyl is just as good! You wouldn’t buy vinyl boots, would you?
WARNING:
Heater elements (when available) should never be installed in
motorcycle seats that will be used by riders that cannot sense heat.
This could create a hazardous condition.
Testimonials:
That Corbin Canyon Dual Sport seat is everything your website said it would be and more! The only reason I stopped after five hours was due to darkness and 45-degree air temperature. Thank you so much for this incredible product! The workmanship was flawless! -James G.
Comments?
Of course we want to hear from you! Have some suggestions for us
or maybe comments for other riders? Send them via
THIS FORM.
Submit Photos:
Showcase your bike on Corbin.com! Use this form to upload photos
for possible inclusion on our website. Ready, set...
LET'S SEE 'EM!
General Contacts
California Factory:
Corbin Saddles
2360 Technology Parkway
Hollister, CA 95023
800-538-7035
Florida Showroom:
Corbin Saddles
1433 North US Highway 1
Ormond Beach, FL 32174
800-223-4332
PLEASE NOTE:
Corbin products are designed to fit very close to your bike for a clean look.
Due to this, other accessories or options can inhibit proper fit. As an example:
Tank Consoles (dashes), ignition modules, exhaust systems, sissy bars, etc.
If you have accessories installed on your bike, please let us know so we can
verify the fit for you.
MILITARY & FIRST RESPONDERS: As a small token of our appreciation for your service to our country, we proudly offer a 10% discount to active military, veterans and first responders. Thank you for what you do! Be sure to notify us when the order is placed, we cannot change orders already in process. Call us at 800-538-7035 so our Reps can apply your discount.
CUSTOM COVERS: You are always welcome to choose from our wide variety of colors and material options for your saddle. We provide these options at no extra charge as long as we can use our existing cover patterns. Creating a new cover design requires specialized custom work and will result in additional charges.
SADDLE WARRANTY:
Basepan, foam and hardware of the Corbin saddle is warranted to the original
owner for life. Cover materials, Heaters and workmanship are warranted for
one year. Product will only be authorized to be shipped back for refining of
shape or to replace/rectify defective parts. In cases where the rework requires
a new cover, a recover charge will be applied. Cash or credit refunds are not
available. All goods being handled for customer service consideration must be
accompanied by a Corbin receipt and a Return Material Authorization number (RMA).
FIBERGLASS WARRANTY:
Structural integrity of Corbin fiberglass components are warranted to the
original owner for life. Finish and paint are warranted against manufacturing
defect for one year. Damage to product and / or painted surfaces from outside
forces or misuse is specifically not covered under warranty. Cash or credit
refunds are not available. All goods being handled for customer service
consideration must be accompanied by a Corbin receipt and a Return Material
Authorization (RMA) number.
EXPORT SALES:
USA pricing shown. When products are shipped throughout the world, you will
see higher prices because of freight, customs, duty & applicable taxes.
Please consider these costs when purchasing Corbin products outside the USA.
If ordering direct from Corbin, we will compute freight charges and add them
to the order. BUYER will be responsible for customs, taxes, duty or other charges.